diff options
Diffstat (limited to 'po/cs.po')
| -rw-r--r-- | po/cs.po | 86 |
1 files changed, 42 insertions, 44 deletions
diff --git a/po/cs.po b/po/cs.po index 6542fb29..2c5834d4 100644 --- a/po/cs.po +++ b/po/cs.po @@ -17,7 +17,7 @@ msgstr "" "Project-Id-Version: NetworkManager\n" "Report-Msgid-Bugs-To: https://gitlab.freedesktop.org/NetworkManager/" "NetworkManager/issues\n" -"POT-Creation-Date: 2022-08-26 16:42+0200\n" +"POT-Creation-Date: 2022-08-11 16:06-0300\n" "PO-Revision-Date: 2018-09-30 14:02+0200\n" "Last-Translator: Daniel Rusek <mail@asciiwolf.com>\n" "Language-Team: Czech <gnome-cs-list@gnome.org>\n" @@ -1200,7 +1200,7 @@ msgstr "" #: src/libnm-core-impl/nm-setting-cdma.c:144 #: src/libnm-core-impl/nm-setting-connection.c:1149 #: src/libnm-core-impl/nm-setting-connection.c:1187 -#: src/libnm-core-impl/nm-setting-connection.c:1516 +#: src/libnm-core-impl/nm-setting-connection.c:1530 #: src/libnm-core-impl/nm-setting-ip-config.c:5423 #: src/libnm-core-impl/nm-setting-ip-tunnel.c:387 #: src/libnm-core-impl/nm-setting-olpc-mesh.c:99 @@ -1545,7 +1545,7 @@ msgstr "" #: src/libnm-core-impl/nm-setting-cdma.c:159 #: src/libnm-core-impl/nm-setting-connection.c:1159 #: src/libnm-core-impl/nm-setting-connection.c:1202 -#: src/libnm-core-impl/nm-setting-connection.c:1454 +#: src/libnm-core-impl/nm-setting-connection.c:1468 #: src/libnm-core-impl/nm-setting-gsm.c:298 #: src/libnm-core-impl/nm-setting-gsm.c:353 #: src/libnm-core-impl/nm-setting-gsm.c:396 @@ -1832,7 +1832,7 @@ msgstr "Chyba: hodnota časového limitu „%s“ není platná." #: src/libnm-core-impl/nm-setting-connection.c:1351 #: src/libnm-core-impl/nm-setting-connection.c:1365 #: src/libnm-core-impl/nm-setting-connection.c:1379 -#: src/libnm-core-impl/nm-setting-connection.c:1440 +#: src/libnm-core-impl/nm-setting-connection.c:1454 #, fuzzy, c-format msgid "value %d is not valid" msgstr "Chyba: hodnota časového limitu „%s“ není platná." @@ -1841,52 +1841,56 @@ msgstr "Chyba: hodnota časového limitu „%s“ není platná." msgid "\"disabled\" flag cannot be combined with other MPTCP flags" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1409 +#: src/libnm-core-impl/nm-setting-connection.c:1411 +msgid "\"enabled\" and \"enabled-on-global-iface\" flag cannot be set together" +msgstr "" + +#: src/libnm-core-impl/nm-setting-connection.c:1422 msgid "cannot set both \"signal\" and \"fullmesh\" MPTCP flags" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1421 +#: src/libnm-core-impl/nm-setting-connection.c:1435 #, fuzzy, c-format msgid "value %u is not a valid combination of MPTCP flags" msgstr "Chyba: hodnota časového limitu „%s“ není platná." -#: src/libnm-core-impl/nm-setting-connection.c:1468 +#: src/libnm-core-impl/nm-setting-connection.c:1482 msgid "DHCP option cannot be longer than 255 characters" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1479 +#: src/libnm-core-impl/nm-setting-connection.c:1493 #, fuzzy msgid "MUD URL is not a valid URL" msgstr "Chyba: příkaz „%s“ není pro „nm“ platný." -#: src/libnm-core-impl/nm-setting-connection.c:1499 +#: src/libnm-core-impl/nm-setting-connection.c:1513 #, fuzzy msgid "invalid permissions not in format \"user:$UNAME[:]\"" msgstr "neplatné pole „%s“" -#: src/libnm-core-impl/nm-setting-connection.c:1528 +#: src/libnm-core-impl/nm-setting-connection.c:1542 #, c-format msgid "property type should be set to '%s'" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1546 +#: src/libnm-core-impl/nm-setting-connection.c:1560 #, c-format msgid "slave-type '%s' requires a '%s' setting in the connection" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1557 +#: src/libnm-core-impl/nm-setting-connection.c:1571 #, c-format msgid "" "Detect a slave connection with '%s' set and a port type '%s'. '%s' should be " "set to '%s'" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1583 +#: src/libnm-core-impl/nm-setting-connection.c:1597 #, c-format msgid "A slave connection with '%s' set to '%s' cannot have a '%s' setting" msgstr "" -#: src/libnm-core-impl/nm-setting-connection.c:1600 +#: src/libnm-core-impl/nm-setting-connection.c:1614 msgid "UUID needs normalization" msgstr "" @@ -5893,29 +5897,25 @@ msgid "" "fc00::/7) and IPv6 privacy extension addresses (rfc3041, ipv6.ip6-privacy) " "will be excluded from being configured as endpoints. If \"disabled\" (0x1), " "MPTCP handling for the interface is disabled and no endpoints are " -"registered. The \"enabled\" (0x2) flag means that MPTCP handling is enabled. " -"This flag can also be implied from the presence of other flags. Even when " -"enabled, MPTCP handling will by default still be disabled unless \"/proc/sys/" -"net/mptcp/enabled\" sysctl is on. NetworkManager does not change the sysctl " -"and this is up to the administrator or distribution. To configure endpoints " -"even if the sysctl is disabled, \"also-without-sysctl\" (0x4) flag can be " -"used. In that case, NetworkManager doesn't look at the sysctl and configures " -"endpoints regardless. Even when enabled, NetworkManager will only configure " -"MPTCP endpoints for a certain address family, if there is a unicast default " -"route (0.0.0.0/0 or ::/0) in the main routing table. The flag \"also-without-" -"default-route\" (0x8) can override that. When MPTCP handling is enabled then " -"endpoints are configured with the specified address flags \"signal\" (0x10), " -"\"subflow\" (0x20), \"backup\" (0x40), \"fullmesh\" (0x80). See ip-mptcp(8) " -"manual for additional information about the flags. If the flags are zero " -"(0x0), the global connection default from NetworkManager.conf is honored. If " -"still unspecified, the fallback is \"enabled,subflow\". Note that this means " -"that MPTCP is by default done depending on the \"/proc/sys/net/mptcp/" -"enabled\" sysctl. NetworkManager does not change the MPTCP limits nor enable " -"MPTCP via \"/proc/sys/net/mptcp/enabled\". That is a host configuration " -"which the admin can change via sysctl and ip-mptcp. Strict reverse path " -"filtering (rp_filter) breaks many MPTCP use cases, so when MPTCP handling " -"for IPv4 addresses on the interface is enabled, NetworkManager would loosen " -"the strict reverse path filtering (1) to the loose setting (2)." +"registered. The flag \"enabled-on-global-iface\" (0x2) means that MPTCP " +"handling is enabled if the interface configures a default route in the main " +"routing table. This choice is per-address family, for example if there is an " +"IPv4 default route 0.0.0.0/0, IPv4 endpoints are configured. The " +"\"enabled\" (0x4) flag means that MPTCP handling is explicitly enabled. This " +"flag can also be implied from the presence of other flags. If MPTCP handling " +"is enabled, then endpoints will be configured with the specified address " +"flags \"signal\" (0x10), \"subflow\" (0x20), \"backup\" (0x40), " +"\"fullmesh\" (0x80). See ip-mptcp(8) manual for additional information about " +"the flags. If the flags are zero, the global connection default from " +"NetworkManager.conf is honored. If still unspecified, the fallback is either " +"\"disabled\" or \"enabled-on-global-iface,subflow\" depending on \"/proc/sys/" +"net/mptcp/enabled\". NetworkManager does not change the MPTCP limits nor " +"enable MPTCP via \"/proc/sys/net/mptcp/enabled\". That is a host " +"configuration which the admin can change via sysctl and ip-mptcp. Strict " +"reverse path filtering (rp_filter) breaks many MPTCP use cases, so when " +"MPTCP handling for IPv4 addresses on the interface is enabled, " +"NetworkManager would loosen the strict reverse path filtering (1) to the " +"loose setting (2)." msgstr "" #: src/libnmc-setting/settings-docs.h.in:18 @@ -7149,13 +7149,11 @@ msgstr "" #: src/libnmc-setting/settings-docs.h.in:200 msgid "" "The gateway associated with this configuration. This is only meaningful if " -"\"addresses\" is also set. Setting the gateway causes NetworkManager to " -"configure a standard default route with the gateway as next hop. This is " -"ignored if \"never-default\" is set. An alternative is to configure the " -"default route explicitly with a manual route and /0 as prefix length. Note " -"that the gateway usually conflicts with routing that NetworkManager " -"configures for WireGuard interfaces, so usually it should not be set in that " -"case. See \"ip4-auto-default-route\"." +"\"addresses\" is also set. The gateway's main purpose is to control the next " +"hop of the standard default route on the device. Hence, the gateway property " +"conflicts with \"never-default\" and will be automatically dropped if the IP " +"configuration is set to never-default. As an alternative to set the gateway, " +"configure a static default route with /0 as prefix length." msgstr "" #: src/libnmc-setting/settings-docs.h.in:175 |